Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 344

Front of engine
Intake side
3 5 10
1 9
7
Exhaust side
Burred side
Head bolt
washer
A
Cylinder
head
ENGINE <4G1> –
REMOVAL SERVICE POINT
AA
Use the special tool to loosen the bolts in 2 or 3 steps in
order of the numbers shown in the illustration, and remove
MB991653
the cylinder head assembly.
Caution
Because the plug guides cannot be replaced by
themselves, be careful not to damage or deform the plug
guides when removing the cylinder head bolts.
8
2
6 4
INSTALLATION SERVICE POINTS
1. Wipe off all oil and grease from the gasket mounting
2. Install so that the shapes of the cylinder head holes match
Head bolt
1. When installing the cylinder head bolts, the length below
(Engine
oil)
2. The head bolt washer should be installed with the burred
3. Apply a small amount of engine oil to the thread section
Cylinder Head Gasket
CYLINDER HEAD BOLT REMOVAL
AA CYLINDER HEAD GASKET INSTALLATION
surface.
the shapes of the respective cylinder head gasket holes.
BA CYLINDER HEAD BOLT INSTALLATION
the head of the bolts should be within the limit.
If it is outside the limit, replace the bolts.
Limit (A): 103.2 mm
side caused by tapping out facing upwards.
and the washer of the cylinder head bolt.
11B-23