Ball Joint Dust Cover Check - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

MB991004
Camber adjusting bolt
Lower arm
REAR SUSPENSION –
CAMBER
Standard value: –0 40' 30'
(The difference between the left and right wheels should
be 30' or less.)
NOTE
For vehicles equipped with aluminium wheels, measure the
camber after tightening the special tool (MB991004) to the
specified torque 180 Nm.
Caution
Do not apply full vehicle load to the wheel bearings when
the flange nuts are loosened. Otherwise the wheel bearings
will break..
If outside the standard value, adjust by the following procedure.
1. Remove the connection between the control link and the
2. Adjust by turning the camber adjusting bolt (mounting bolt
88 Nm
3. Tighten the control link to the trailing arm at the specified
4. After adjusting the camber, be sure to adjust the toe-in.
34 Nm

BALL JOINT DUST COVER CHECK

1. Check the dust cover for cracks or damage by pushing
2. If the dust cover is cracks or damaged, replace the lower
On-vehicle Service
trailing arm.
for the lower arm and rear crossmember).
Left wheel: clockwise + camber
Right wheel: clockwise – camber
The scale has gradations of approximately 14'
torque.
it with finger.
arm assembly.
NOTE
Cracks or damage of the dust cover may cause damage
of the ball joint.
34-5
33200860076