Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 851

42-8
WORKING PROCESS
Body side
Cleaning of adhesion surface
Cut off the residual adhesive until the
thickness is less than 2 mm. Clean the
adhesion surface with isopropyl alco-
hol, and let dry for 3 minutes or more.
Attaching of window spacer
Attach the window spacer to set the
positions for the glass to be installed.
Application of primer
Apply to the adhesion surface of the
body and let dry for 3 minutes or more.
Installing the glass
After applying the adhesive, lightly press the glass evenly so that it adheres
completely.
Cleaning
After removing any adhesive that is sticking out or adhering to the body or
glass with a spatula, ect., clean off with isopropyl alcohol.
Checking for water leaks
Carry out a shower test to check that no water will leak through.
BODY –
Window Glass
Window glass installation procedure
Window glass side
Reusing the glass
Cleaning of adhesion surface
Competely cut off all of the residual
adhesive. Clean the adhesion surface
with isopropyl alcohol, and let dry for
3 minutes or more.
Gluing of window spacer and window dam
Glue the window spacer and window dam to the glass, following the standard position all
the way around the inside edge of the glass.
Application of primer
Apply sufficient primer evenly to the adhesion surface so that there is no patchiness. After
application, let dry for 3 to 30 minutes.
Application of adhesive
Within 30 minutes after applying the primer, apply the adhesive evenly all the way around
the inside edge of the glass.
Replacing the glass
Cleaning of adhesion surface
Clean off any dirt adhering to the adhe-
sion surface with isopropyl alcohol, and
let dry for 3 minutes or more.