Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 64

Corrugated washer
OK NG
f ×
GDI <4G6> - GDI <4G6> -
Injector Injector
REMOVAL SERVICE POINTS
AA" INJECTOR HARNESS CONNECTOR
DISCONNECTION
Caution
Disconnect the battery ( - ) cable from its terminal before
carrying out this operation.
AB" DELIVERY PIPE ASSEMBLY/FUEL INJECTOR
ASSEMBLY REMOVAL
Remove the delivery pipe assembly with the fuel injector
assembly still attached.
Caution
Be careful not to drop the fuel injector assembly when
removing the delivery pipe assembly.
INSTALLATION SERVICE POINTS
"AA CORRUGATED WASHER INSTALLATION
Caution
1. The corrugated washer should always be replaced
with a new part.
2. There should be no scratches or foreign particles
on the corrugated washer mounting surface of the
injector.
3. Be careful not to mistake the corrugated washer
installation direction.
"BA FUEL INJECTOR ASSEMBLY/DELIVERY PIPE
ASSEMBLY INSTALLATION
1. Apply a small amount of fresh engine oil to the O-ring.
Caution
Take care not to let any of the engine oil get inside
the delivery pipe assembly.
2. While being careful not to damage the O-ring, turn the
fuel injector assembly to the left and right and connect
it to the delivery pipe assembly. After connecting, check
that the fuel injector turns smoothly.
3. If the fuel injector does not turn smoothly, the cause may
be that the O-ring is getting caught. Remove the fuel
injector, check the O-ring for damage and re-connect the
fuel injector to the delivery pipe assembly and then
re-check.
13A-19