Sealants - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

14-18
ENGINE COOLING –
Thermostat case assembly or cylinder block
O-ring
Water inlet pipe assembly
Water Hose and Water Pipe
INSTALLATION SERVICE POINTS
AA O-RING INSTALLATION
Insert the O-ring to the water inlet pipe assembly, and coat
the outer circumference of the O-ring with water or engine
coolant.
Caution
Do not allow engine oil or other greases to adhere to
the O-ring
BA /THERMOSTAT CASE ASSEMBLY INSTALLATION
Squeeze out the sealant from the tube evenly and apply it
so that there is not too much sealant and no places without
sealant.
Specified Sealant:
Mitsubishi Genuine Parts No. MD970389 or equivalent
CA RADIATOR UPPER HOSE/RADIATOR LOWER
HOSE CONNECTION
1. Insert each hose as far as the projection of the water
inlet fitting.
2. Align the mating marks on the radiator hose and hose
clamp, and then connect the radiator hose.
INSPECTION
WATER PIPE AND HOSE CHECK
Check the water pipe and hose for cracks, damage, clog and
replace them if necessary.
14100340101