Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 970

Air bag module
deployment section
Side impact
Center pillar
sensor
SRS –
SRS Maintenance
FRONT SEAT BACK ASSEMBLY (SIDE AIR BAG
MODULE)
1. Check that there is no abnormality in the seat air bag
module deployment section.
2. Check that there is no connector damage, bent terminals
or clamping of the harness.
SIDE IMPACT SENSORS
1. Check that there is no bending or corrosion in the center
pillar.
2. Check that there is no denting, breakage, bending or
corrosion of the side impact sensor.
3. Check that there is no clamping of the harness, connector
damage or bent terminals.
NOTE
The illustration at left shows the side impact sensor (R.H.).
The position of the side impact sensor (L.H.) is symmetrical
to this.
Caution
The SRS may not activate if the side impact sensors
are not installed properly, which could result in serious
injury or death to the vehicle's driver or front
passenger.
52B-21