Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 567

13C-4
Mating range
Mating
marks
OK
FUEL SUPPLY –
INSTALLATION SERVICE POINTS
AA FUEL PUMP MODULE INSTALLATION
1. Check to be sure that the fuel tank packing is not damaged
or deformed, and then securely install the packing to the
fuel tank.
Caution
If the packing is installed to the fuel pump module,
packing lip will be damaged when installing the fuel
pump module to the fuel tank and the fuel leak will
result.
NOTE
If the packing is damaged or deformed, replace the
(Not good)
defective packing with a new packing.
2. Apply soapy water to the inside of the packing. Align the
mating marks on the fuel tank and fuel pump module
as shown in the illustration, and then install the fuel pump
Packing module to the fuel tank.
Caution
(1) Do not tilt the fuel pump module when installing.
(2) The packing should not be folded over as shown
BA CAP INSTALLATION
Apply soapy water to the cap thread, and then use the special
tool as the same manner as for removal to tighten the cap
MB996009
to the specified torque.
Tightening torque: 49 Nm
Caution
Prevent the fuel pump module from turning with the cap
when tightening the cap.
INSPECTION
FUEL PUMP MODULE REPLACEMENT
MB996009
1. Bleed the residual pressure from inside the fuel pipe line
to prevent the fuel from spraying out. (Refer to GROUP
13 – On-vehicle Service.)
2. Disconnect the fuel hoses.
3. Use the special tool to remove the cap, and then remove
the fuel pump module.
Fuel Tank
by (A) in the illustration.
13500160207