Brake Lining Thickness Check; Brake Drum Inside Diameter Check; Brake Lining And Brake Drum Connection Check - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

35A-14
BASIC BRAKE SYSTEMS –

BRAKE LINING THICKNESS CHECK

1. Remove the brake drum.
2. Measure the wear of the brake lining at the place worn

BRAKE DRUM INSIDE DIAMETER CHECK

1. Remove the brake drum.
2. Measure the inside diameter of the brake drum at two
3. Replace brake drums, shoe and lining assembly when
BRAKE LINING AND BRAKE DRUM
CONNECTION CHECK
1. Remove the brake drum.
2. Remove the shoe and lining assembly. (Refer to P.35A-22.)
3. Chalk inner surface of brake drum and rub with shoe and
4. Replace shoe and lining assembly or brake drums if there
On-vehicle Service
the most.
Standard value: 4.38 mm
Limit: 1.0 mm
Replace the shoe and lining assembly if brake lining
thickness is less than the limit if it is not worn evenly.
For information concerning the procedures for installation
of the shoe and lining assembly, refer to P.35A-22.
Caution
(1) Whenever the shoe and lining assembly is
replaced, replace both RH and LH assemblies as
a set to prevent car from pulling to one side when
braking.
(2) If there is a significant difference in the thickness
of the shoe and lining assemblies on the left and
right sides, check the sliding condition of the
piston.
or more locations.
Standard value: 203 mm
Limit: 205 mm
wear exceeds the limit value or is badly imbalanced.
lining assembly.
are any irregular contact area.
NOTE
Clean off chalk after check.
35100300241
35100320049
35100310053