On-Vehicle Service; Door Fit Adjustment; Window - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

Hide thumbs Also See for Space Runner 1999:

Table of Contents

ON-VEHICLE SERVICE

1. If the clearance between the door and the vehicle body

2. If the door and the body are not flush with each other,

3. If the striker and latch do not mesh properly, adjust the

ADJUSTMENT AND REPLACEMENT WHEN

THERE IS A MALFUNCTION OF THE POWER

If the window glass automatically starts moving downwards

at the wrong time while it is being raised, carry out the following

adjustment or replacement procedures.

1. Remove the door trim and waterproof film. (Refer to

2. Remove the window regulator assembly from the door

3. If the door window glace does not move up and down

is uneven, affix protective tape to the fender around the

hinge and to the edge of the door. Then use the special

tool to loosen the door hinge mounting bolts on the body,

and adjust the clearance around the door so that it becomes

use the special tool to loosen the door hinge mounting

bolts. Then align the door.

position of the striker.

window glace, and then raise and lower the door window

glass by hand to check the operation force.

smoothly, repair the twisting in the door sash, or adjust

the sash span by loosening the lower sash or center sash

mounting bolts and pushing apart the lower sash or center

sash while tightening the bolts again. If repair or adjustment

is not possible, replace the door assembly.

The lower sash cannot normally be adjusted, but it may

be possible to adjust it slightly within the range by

manufacturing tolerances.

Show Quick Links

Table of Contents