Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 229

26-2
GENERAL
OUTLINE OF CHANGE
D The following service procedures have been established in line with the addition of 2000 models
and 2400 models.
(1) DRIVE SHAFT REMOVAL AND INSTALLATION
(2) DRIVE SHAFT DISASSEMBLY AND REASSEMBLY
DRIVE SHAFT
REMOVAL AND INSTALLATION
Caution
On the vehicles with ABS, when the drive shaft is removed or installed, be careful not to interfere
with the ABS rotor installed to the B.J. outer race to prevent the ABS rotor from damage.
Post-installation Operation
Check the Dust Cover for Cracks or Damage by Pushing
it with Finger.
4
39 Nm
2
196 - 255 Nm
Removal steps
1. Front wheel speed sensor
<Vehicles with ABS>
AA" "BA 2. Drive shaft nut
AB" 3. Tie rod end connection
4. Stabilizer link connection
FRONT AXLE -
6
96 - 118 Nm
5
General/Drive Shaft
3
1
24 - 33 Nm
AC" "AA 6. Drive shaft
AC" "AA 7. Drive shaft and inner shaft
<2000-A/T>
6 <2000-M/T, 2400>
7
5. Lower arm assembly connection
assembly
40 Nm