Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 783

35A-20
FRONT DISC BRAKE
REMOVAL AND INSTALLATION
Pre-removal Operation
Brake Fluid Draining
80 – 95 Nm
Removal steps
1. Brake hose connection
2. Gasket
AA 3. Disc brake assembly
4. Brake disc
MB990998
226 Nm
BASIC BRAKE SYSTEMS –
1
29 Nm
2
INSTALLATION SERVICE POINT
1. In order to measure the brake drag torque after pad
Bolt
Front Disc Brake
Post-installation Operation
D
Brake Fluid Supplying
D
Brake Line Bleeding (Refer to P.35A-10.)
3
AA DISC BRAKE ASSEMBLY INSTALLATION
installation, measure the rotary-sliding resistance of the
hub (A) by the following procedure with the pads removed.
(1) Remove the drive shaft. (Refer to GROUP 26 – Front
Axle.)
(2) Attach the special tool to the front hub assembly as
shown in the illustration, and tighten it to the specified
torque.
(3) Use a spring balance to measure the rotary-sliding
resistance of the hub in the forward direction.
35100600204
4