Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 711

26-10
MB990998
Tighten the nut with
the bolt secured
MB990998
MB990326
MB990998
Turn the nut
216 – 255 Nm
FRONT AXLE –
1. Use the special tool to mount the hub onto the knuckle.
2. Tighten the nut of the special tool to 216–255 Nm.
3. Rotate the hub in order to seat the bearing.
MB991017
4. Measure the wheel bearing starting torque (hub starting
5. The starting torque must be within the limit and, in addition,
MB990685
1. Measure to determine whether the axial play of the hub
2. If the starting torque and hub axial play are not within
MB991389
1. Apply multipurpose grease to the reverse side of the inner
2. Drive the inner oil seal into the knuckle until it contacts
3. Apply multipurpose grease to the lip of the inner oil seal.
INSPECTION
D
D
D
Axle Hub
CA WHEEL BEARING STARTING TORQUE CHECK
torque) by using the special tools.
Limit: 1.8 Nm or less
the bearing must not feel rough when rotated.
DA HUB AXIAL PLAY CHECK
is within the specified limit or not.
Limit: 0.05 mm
the limit range while the nut is tightened to 216–255 Nm,
the bearing, hub and/or knuckle have probably not been
installed correctly. Replace the bearing and re-install.
EA INNER OIL SEAL INSTALLATION
oil seal.
the snap ring.
Check the front hub and brake disc mounting surfaces
for galling and contamination.
Check the knuckle inner surface for galling and cracks.
Check for defective bearing.
26100200013