Secret Code Registration Method - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

42-56
MUT-II connected
Within 10 seconds
ON
Hazard
switch
OFF
BODY –
Keyless Entry System

SECRET CODE REGISTRATION METHOD

Each individual secret code is registered inside the transmitter,
and so it is necessary to register these codes with the EEPROM
inside the receiver in the following cases.
When either the transmitter or receiver is replaced;
If a second transmitter is to be used;
If it appears that a problem is occurring because of faulty
registration of a code.
A maximum of two different codes can be stored in the memory
area of the EEPROM (two different transmitters can be used).
When the code for the first transmitter is registered, the
previously-registered codes for two transmitters are cleared.
Therefore, if you are using two transmitters or are adding
a second transmitter, the codes for both transmitters must
be registered at the same time.
1. Check that the doors lock normally when the key is used.
2. Connect the MUT-II to the diagnosis connector.
NOTE
This will connect terminal (1) of the diagnosis connector
to earth, and the system will be in secret code registration
standby mode.
Caution
Always turn the ignition switch to OFF before
connecting and disconnecting the MUT-II.
3. Within 10 seconds after connecting the MUT-II, turn the
hazard switch to ON and then to OFF; repeat this procedure
six times.
NOTE
The doors will lock and unlock once at this time and the
system will switch to registration mode.
4. Press the transmitter switch, and then press it two times
within 10 seconds of the first press. This will register the
code.
5. After registration is completed, the doors will be
automatically locked and unlocked once.
6. If you are using two transmitters or have added a second
transmitter, the same registration procedure should be
carried out for the second transmitter, and it should be
carried out within one minute after registration of the code
for the first transmitter has been completed. After the
second registration is completed, the doors will be
automatically locked and unlocked once.
7. Registration mode will be cancelled under the following
conditions.
When the secret codes for two transmitters have been
registered;
42800100109