Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 986

SEAT BELT WITH PRE-TENSIONER
Caution
1. Never attempt to disassemble or repair the
seat belt with pre-tensioner. If faulty, replace
it.
2. Be extremely careful when handling the seat
belt with pre-tensioner. Do not subject it to
shocks, drop it, bring it close to strong
magnets or allow contact with water, grease
or oil. Always replace it with a new part if
any dents, cracks or deformation is found.
3. Do not place anything on top of the seat
belt pre-tensioner.
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Center Pillar Lower Trim Removal and Installation (Refer
to GROUP 52A.)
Removal steps
BA D Post-installation inspection
1. Sash guide cover
2. Sash guide
SRS –
Seat Belt with Pre-tensioner
4. Do not expose
pre-tensioner to temperatures over 90_C.
5. After operating the seat belt pre-tensioner,
replace the seat belt pre-tensioner with a
new part.
6. Gloves and protective goggles should be
worn when handling a pre-tensioner once
it has been used.
7. If disposing of a seat belt with pre-tensioner
which has not
pre-tensioner should be operated first before
disposal. (Refer to P.52B-39.)
44 Nm
2
1
3
44 Nm
3. Seat belt with pre-tensioner
AA D Pre-installation inspection
52B-37
52400410063
the seat belt with
yet been used, its