Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 987

52B-38
SRS warning lamp
SRS –
Seat Belt with Pre-tensioner
INSTALLATION SERVICE POINTS
AA PRE-INSTALLATION INSPECTION
When installing a new seat belt with pre-tensioner refer to
"INSPECTION".
Caution
Disposal of the pre-tensioner must be carried out as stated
in the procedure. (Refer to P.52B-39.)
BA POST-INSTALLATION INSPECTION
1. Reconnect the negative battery terminal.
2. Turn the ignition key to the "ON" position.
3. Does the "SRS" warning lamp illuminate for about 7
seconds, and then remain extinguished for at least 5
seconds after turning OFF?
4. If yes, SRS system is functioning properly. If no, consult
page 52B-7.
INSPECTION
SEAT BELT WITH PRE-TENSIONER CHECK
If any part is found to be faulty during the inspection, it must
be replaced with a new one.
Dispose of the old one according to the specified procedure.
(Refer to P.52B-39.)
D
Check seat belt pre-tensioner for dents, cracks or
deformation.
52400420066