On-Vehicle Service; Rear Wheel Alignment Check And Adjustment - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

34-4
REAR SUSPENSION –
Tool
Toe-in adjusting bolt
88 Nm
Control link
Special Tools/On-vehicle Service
Number Name
MB991237 Spring compressor
body
MB991239 Arm set
MB990326 Preload socket
MB990685 Torque wrench

ON-VEHICLE SERVICE

REAR WHEEL ALIGNMENT CHECK AND
ADJUSTMENT
Measure the wheel alignment with the vehicle parked on level
ground.
The rear suspension and wheels should be serviced to the
normal condition prior to measurement of wheel alignment.
TOE-IN
Standard value:
At the centre of tyre tread 3 2 mm
Toe angle (per wheel) 0 09' 06'
If outside the standard value, adjust by the following procedure.
1. Be sure to adjust the camber before adjusting the toe-in.
2. Adjust by turning the toe adjusting bolt (mounting bolt
on the inside of the control link).
LH: Turning clockwise
RH: Turning clockwise
The scale has gradations of approximately 2.6 mm (single
side toe angle equivalent to 16')
Use
Compression of the front coil spring
Checking of stabilizer link ball joint for turning
torque
toe-in direction
toe-out direction
33100100137