Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 867

42-24
<Rear>
Carry out the initial setting operation.
(Refer to P.42-31.)
Check trouble symptoms.
NG
Power window main switch check
(Refer to P.42-40.)
OK
Power window sub-switch check
(Refer to P.42-41.)
OK
Measure at the power window sub-
switch connector(L.H.) E-07
or (R.H.) E-17.
Ignition switch (IG2): ON
Disconnect the connector and
measure at the harness side.
Voltage between 1 and body earth
(When main switch is at AUTO)
OK: System voltage
OK
Measure at the power window motor
connector(L.H.) E-08 or (R.H.) E-18.
Disconnect the connector and
measure at the harness side.
Voltage between 2 and body earth
(When sub-switch is at AUTO)
OK: System voltage
OK
Replace the power window regulator
assembly.
Inspection Procedure 6
When the glass is raised, it then lowers automatically.
The sliding resistance is too large when the glass rises. So it is misjudged that
something is jammed in the window, and the window is lowered automatically.
Adjustment and replacement when there is a malfunction of the
power window
Replace the power window regulator assembly.
BODY –
NG
Replace
NG
Replace
NG
Check the following connectors:
<L.H.> E-03, B-41, D-17, E-07
<R.H.> E-03, B-41, D-05, E-17
Check trouble symptoms.
Check the harness between the power
window main switch and power window
sub-switch. Repair, if necessary.
NG
Check the following connectors:
<L.H.> E-07, E-08
<R.H.> E-17, E-18
Check trouble symptoms.
Check the harness between the power
window sub-switch and power window
motor. Repair, if necessary.
OK
Door
NG
OK
NG
NG
OK
NG
Probable cause
Incorrect installation or bending of the glass runners.
Malfunction of the power window regulator assembly
NG
Replace the door assembly.
Repair
Repair