Accelerator Pedal Position Sensor Check; Accelerator Pedal Position Switch Check - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

Equipment side connector
Accelerator pedal position sensor
Equipment side connector
Accelerator pedal position sensor
GDI –
On-vehicle Service
ACCELERATOR PEDAL POSITION SENSOR
CHECK
1. Disconnect
connector.
2. Measure resistance between terminal Nos.2 and 1 as well
as Nos.8 and 7 of the sensor connector.
Standard value: 3.5 – 6.5 kΩ
3. Measure resistance between terminal Nos.2 and 3 as well
as 8 and 6 of the accelerator pedal position sensor
connector, respectively.
Normal condition:
Depress the accelerator
pedal slowly.
4. If not within the standard value, or resistance value does
not change smoothly, replace the accelerator pedal position
sensor assembly.
NOTE
After replacement, adjust the accelerator pedal position
sensor. (Refer to P.13A-97.)
ACCELERATOR PEDAL POSITION SWITCH
CHECK
1. Disconnect
connector.
2. Check continuity between terminal Nos. 4 (accelerator
pedal position switch) and 5 (sensor earth) of the
accelerator pedal position sensor.
Normal condition
Accelerator pedal
Depress
Release
3. If defective, replace the accelerator pedal position sensor
assembly.
NOTE
After replacement, adjust the accelerator pedal position
sensor and switch. (Refer to P.13A-97.)
the accelerator pedal
Resistance value changes in
accordance with the
accelerator pedal
depression smoothly.
the accelerator pedal
Continuity
No continuity
Continuity
13A-107
position sensor
position sensor