Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 862

INSPECTION PROCEDURE FOR TROUBLE SYMPTOMS
Inspection Precedure 1
Driver's power window cannot be operated by the power
window main switch.
The power window main switch or power window regulator assembly may be defective.
Power window main switch check
(Refer to P.42-40.)
OK
Measure at the power window motor
connector (driver's side) E-11.
Disconnect the connector and
measure at the harness side
Voltage between 6 and body earth
OK: System voltage
OK
Measure at the power window motor
connector (driver's side) E-11.
Disconnect the connector and
measure at the harness side
Continuity between 1 and body earth
OK: Continuity
OK
Measure at the power window motor
connector (driver's side) E-11.
Disconnect the connector and
measure at the harness side
Ignition switch (IG2): ON
Voltage between 5 and body earth
(When switch is at UP)
Voltage between 4 and body earth
(When switch is at DOWN)
Voltage between 2 and body earth
(When switch is at AUTO)
OK: System voltage
OK
Replace the power window regulator
assembly.
BODY –
NG
Replace
NG
Check the following connectors:
E-11, B-41, B-45
Check trouble symptoms.
NG
Check the following connector:
E-11
Check trouble symptoms.
NG
Check the following connectors:
E-03, E-11
Check trouble symptoms.
Door
Probable cause
Malfunction of power window regulator assembly
Malfunction of power window main switch
Malfunction of wiring harness or connector
NG
OK
NG
NG
OK
NG
NG
OK
NG
42-19
Repair
Check the harness wire between power
window motor and fusible link No.6,
and repair if necessary.
Repair
Check the harness wire between power
window motor and intermediate con-
nector, and repair if necessary.
Repair
Check the harness wire between power
window main switch and power window
motor, and repair if necessary.