Steering gear and linkage
Crossmember
Transmission jack
Outside of vehicle
Identification mark
POWER PLANT MOUNT –
REMOVAL SERVICE POINT
AA
1. Move the crossmember while supporting the steering gear
2. Remove the crossmember while supporting it with a
Crossmember
INSTALLATION SERVICE POINT
AA STABILIZER BAR INSTALLATION
Place the identification mark of the stabilizer bar to the right,
and install the bushing so that the identification mark is at
the shown position.
BA CROSSMEMBER ASSEMBLY INSTALLATION
Install the crossmember while supporting it with a transmission
jack.
CA
Tighten the self-locking nut so that the amount of protrusion
of the end of the stabilizer bar mounting bolt is at the standard
A
value.
Standard value (A): 22 mm
Crossmember
CROSSMEMBER ASSEMBLY REMOVAL
and linkage in the direction shown by the arrow.
transmission jack.
SELF-LOCKING NUT INSTALLATION
32-7