On-Vehicle Service; Wheel Bearing Axial Play Check; Rear Hub Rotary-Sliding Resistance Check; Hub Bolt Replacement - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

Hide thumbs Also See for Space Runner 1999:

Table of Contents

ON-VEHICLE SERVICE

1. Remove the brake drum.

2. Check the bearing's axial play.

Place a dial gauge against the hub surface; then move

the hub in the axial direction and check whether or not

there is axial play.

Limit: 0.05 mm

3. If the axial play exceeds the limit, the flange nut should

be tightened to the specified torque (172 Nm) and check

the axial play again.

4. Replace the rear hub assembly if an adjustment cannot

be made to within the limit.

REAR HUB ROTARY-SLIDING RESISTANCE

1. Remove the brake drum.

2. After turning the hub a few times to seat the bearing,

wind a rope around the hub bolt and turn the hub by

pulling at a 90 angle with a spring balance. Measure

to determine whether or not the rotary-sliding resistance

of the rear hub is at the limit value.

Limit: 19 N or less

3. If the limit value is exceeded, loosen the flange nut and

then tighten it to the specified torque (172 Nm) and check

the rear hub rotary sliding resistance again.

4. Replace the rear hub assembly if an adjustment cannot

be made to within the limit.

1. Remove the brake drum.

2. Use the special tools to remove the hub bolts.

On-vehicle Service

Show Quick Links

Table of Contents