Power Steering Oil Pressure Switch Check - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

Adapter
(MB990993)
Pressure
gauge
(MB990662)
Temperature
gauge
Oil
pump
Reservoir
STEERING –
On-vehicle Service
POWER STEERING OIL PRESSURE SWITCH
CHECK
Shut-off valve
1. Disconnect the pressure hose from the oil pump, and then
connect the special tools.
2. Bleed the air, and then turn the steering wheel several
times while the vehicle is not moving so that the
temperature of the fluid rises to approximately 50 – 60 C.
3. The engine should be idling.
4. Disconnect the connection of the connector for the oil
pressure switch, and place an ohmmeter in position.
5. Gradually close the shut-off valve of the pressure gauge
and increase the hydraulic pressure, then check whether
or not the hydraulic pressure that activates the switch
is the standard value.
Standard value: 1.8 – 2.4 MPa
Adapter
(MB990994)
6. Gradually open the shut-off valve and reduce the hydraulic
pressure; then check whether or not the hydraulic pressure
that deactivates the switch is the standard value.
Standard value: 1.0 – 2.4 MPa
7. Remove the special tools, and then tighten the pressure
hose to the specified torque.
Tightening torque: 17 Nm
8. Bleed the system.
37A-11
37200720198