Brake Fluid Level Sensor Check; Bleeding - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

35A-10
4 (2)
2 (4)
( ): R.H. drive vehicles
BASIC BRAKE SYSTEMS –
4. If the measured pressures are not within the permissible

BRAKE FLUID LEVEL SENSOR CHECK

The brake fluid level sensor is in good condition if there is
no continuity when the float surface is above "MIN" and if
there is continuity when the float surface is below "MIN".
"MIN"

BLEEDING

Caution
Use the specified brake fluid. Avoid using a mixture of
the specified brake fluid and other fluid.
Specified brake fluid: DOT3 or DOT4
MASTER CYLINDER BLEEDING
The master cylinder used has no check valve, so if bleeding
is carried out by the following procedure, bleeding of air from
the brake pipeline will become easier. (When brake fluid is
not contained in the master cylinder.)
1. Fill the reserve tank with brake fluid.
2. Keep the brake pedal depressed.
3. Have another person cover the master cylinder outlet with
4. With the outlet still closed, release the brake pedal.
5. Repeat steps2.–4. three or four times to fill the inside
BRAKE PIPE LINE BLEEDING
Bleed the air in the sequence shown in the figure.
1 (3)
3 (1)
On-vehicle Service
(3) Output pressure difference between left and right brake
lines.
Limit: 0.4 MPa
ranges, replace the proportioning valve.
a finger.
of the master cylinder with brake fluid.
35100910048
35100140195