Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 859

42-16
Clip
21 mm
Glass edge
Dual-lock
fastener
Projections
2 mm
Tailgate glass side dam
BODY –
REMOVAL SERVICE POINT
AA
Remove the tailgate window glass by the same procedure
as for the windshield. (Refer to P.42-10.)
INSTALLATION SERVICE POINT
Centre
1. Use isopropyl alcohol to degrease the inside and outside
300 mm
2. Attach the clips to the inside of the tailgate glass in the
3. Install the dual lock fasteners between the projections
Tailgate
outer panel
4. Attach the tailgate glass dams to the edge of the tailgate
5. Apply primer and adhesive. (Refer to P.42-15.)
Tailgate glass edge
6. Install the glass in the same way as for the windshield.
Tailgate glass
upper dam
Window Glass
TAILGATE WINDOW GLASS REMOVAL
AA CLIP/DUAL-LOCK FASTENER/TAILGATE GLASS
LOWER DAM/TAILGATE GLASS SIDE
DAM/TAILGATE GLASS UPPER DAM/TAILGATE
WINDOW GLASS INSTALLATION
edges of the tailgate window glass and the surface of
the body flange.
positions shown in the illustration.
on the tailgate outer panel, and then install them in
matching positions on the glass.
glass.
(Refer to P.42-11.)