Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 357

12-4
<GDI>
39 Nm
<MPI>
39 Nm
Barometric temperature
ENGINE LUBRICATION – ENGINE LUBRICATION –
ENGINE OIL REPLACEMENT
Drain plug gasket
1. Start the engine and allow it to warm up until the
2. Remove the engine oil filler cap.
Oil pan
3. Remove the drain plug to drain oil.
side
4. Install a new drain plug gasket so that it faces in the
Drain plug gasket
Oil pan
side
5. Refill with specified quantity of oil.
6. Install the engine oil filler cap.
7. Check oil level.
OIL FILTER REPLACEMENT
MB991396, 1. Start the engine and allow it to warm up until the
MB991610
or commercially-
2. Remove the engine oil filler cap.
available
3. Remove the drain plug to drain oil.
tool
4. Use the following tools to remove the engine oil filter from
5. Clean the filter bracket side mounting surface.
On-vehicle Service On-vehicle Service
temperature of the coolant reaches 80 C to 90 C.
Caution
Use care as oil could be hot.
direction shown in the illustration, and then tighten the
drain plug to the specified torque.
Specified Engine Oil (API classification): SG or higher
Total quantity (Includes volume inside oil filter):
<GDI> 3.8
<MPI> 3.3
temperature of the coolant reaches 80 C to 90 C.
Caution
Use care as oil could be hot.
the underside of the vehicle.
MD991396 or equivalent (When using the oil filter
of MD135737)
MD991610 or equivalent (When using the oil filter
of MD136466)
Commercial tool (When using the oil filter except for
MD135737 and MD136466)
12100100255
12100110241