Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 206

GENERAL
OUTLINE OF CHANGE
D The following service procedures have been established in line with the addition of a clutch switch.
<2400>
(1) CLUTCH PEDAL INSPECTION AND ADJUSTMENT
(2) CLUTCH PEDAL REMOVAL AND INSTALLATION
(3) CLUTCH SWITCH CHECK
Setting nut
13 Nm
Push rod
CLUTCH -
General/On-vehicle Service
GROUP 21
CLUTCH
ON-VEHICLE SERVICE
CLUTCH PEDAL INSPECTION AND
ADJUSTMENT <2400>
The following clutch pedal height inspection and adjustment
procedures have been established. Items other than those
below are the same as before.
1. Measure the height of the clutch pedal in the same
procedure as before.
2. When the clutch pedal height does not meet the standard
value, adjust as follows:
(1) Disconnect the clutch switch connector.
(2) Turn the clutch switch counter-clockwise about 1/4
(3) Turn the setting nut to adjust so that the clutch pedal
Clutch
switch
0.5 - 1.5 mm
(4) Turn the clutch switch about 1/4 of a turn clockwise
(5) Connect the clutch switch connector.
time to loosen.
height is within the standard value range.
Caution
Do not push in the master cylinder push rod at
this time, otherwise the clutch will not operate
properly.
to tighten it so that the gap is as shown in the
illustration.
21-1