Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 983

52B-34
Protective tubes
Protective tubes
3
1
Paint
mark
SRS check
harness
(MB991613)
4
A
5
View A
SIDE IMPACT SENSOR
SRS – Side Impact Sensor
CLOCK SPRING CHECK
Case
If, as result of following checks, even one abnormal point
is discovered, replace the clock spring with a new one.
1. Check connectors and protective tubes for damage, and
2. Visually check the case for damage.
3. Check that there is continuity between terminal (3) of the
4
2
4. Align the paint mark of the SRS check harness connector
Notch
5. Check continuity between the terminals 22 and 23 of the
Clock spring
connector 2
Caution
If dents, cracks, deformation, or rust are discovered
in the air bag module, replace it with a new one.
Dispose of the old one according to the specified
procedure. (Refer to P.52B-39.)
terminals for deformation.
clock spring No.1 connector and the No. 2 connector.
No.4 with the notch in clock spring connector No.2 to
connect the connectors Nos.2 and 4.
SRS check harness connector No.5.
52400460044