Related Manuals for Mitsubishi MOTORS i-MiEV
Summary of Contents for Mitsubishi MOTORS i-MiEV
- Page 1 Accident and Emergency Rescue Manual (2010 MY vehicle)
- Page 2 Failure to follow these instructions and especially the warnings and cautions may result in serious injury such as an electrical shock due to the high voltage battery installed on i-MiEV. Please read and understand this manual carefully for your and the passengers safety.
- Page 3 1. Safety precautions for handling high voltage. (1) Isolation from the high voltage circuit (2) Disconnection of the high voltage circuit (3) Precautions when rescuing passengers 2. Exterior and interior features to identify i-MiEV. (1) Exterior (2) Interior (3) Chassis number 3.
- Page 4 1. Safety precaution for handling high voltage. Since i-MiEV has a high voltage circuit with a 330V Lithium-ion battery for the electric motor unit and other components, it is necessary to ensure “isolation” and “cut off” from the high voltage circuit in order to prevent the risk of electric shock before handling the vehicle.
- Page 5 2. Exterior and interior features to identify i-MiEV. All i-MiEV vehicles sold in Australia by Mitsubishi Motors Australia Ltd have a high voltage circuit with a 330V Lithium-ion battery for the electric motor unit and other components. Please handle using the appropriate Personal Protective Equipment (PPE) and only the methods described in this manual.
- Page 6 Gear shift panel Instrument panel Gear shift panel Instrument panel An energy usage indicator is located in the i-MiEV The indication on the panel is different. instrument panel. A state of charge gauge is also installed top LHS. Copyright © Mitsubishi Motors Australia Limited...
- Page 7 Chassis number stamp HA3W-0000010 The first 4 digits are “HA3W” for i-MiEV. ・Caution plate (Center pillar of passenger’s side) The first 4 digits of Chassis Number are “HA3W” for i-MiEV. Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
- Page 8 “HIGH VOLTAGE” condition exists. (Please refer the example on page 19). Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
- Page 9 Case 2 (page 10). If cutting the vehicle body is necessary for rescue operations, refer to Case 2 (page 10) or Case 3 (page 11) as applicable. Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
- Page 10 5 minutes after removing the service plug before cutting the vehicle body. Never cut the main battery itself. Refer to Case 3 (page 11 and 12) for location of main battery. Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
- Page 11 Do not cut in the areas coloured (shaded), to prevent the risk of high voltage electric shock. （The bottom view shows the condition when the under cover is removed.） Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
- Page 12 Pretensioner （Built in retractor） Side detect sensor Front impact sensor Rear detect Floor sensor harness Driver side Passenger side airbag module airbag module Warning lamp Clock spring Floor SRS-ECU Diagnosis connector harness Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
- Page 13 Never extinguish with a small quantity of water, always use a large quantity or volume of water – for example from a fire hydrant, otherwise wait until the fire service/department arrives. Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
- Page 14 This isolates the electricity supply to the SRS airbags system. ① Remove the auxiliary battery cover under the bonnet. ② Disconnect negative terminal from auxiliary battery. 12V Battery Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
- Page 15 Before leaving the vehicle unattended, the service lid should be reinstalled and secured (were possible) to prevent any accidental contact. Do not reinstall the service plug. Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
- Page 16 Transport the vehicle as per “Vehicle dimensions and precautions for transporting a damaged vehicle” on page 17. WARNING; Always wear suitable Personal Protective Equipment when removing the service plug! Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
- Page 17 ・ Figure shows examples of carrying statement. ・ When loading the vehicle on the carrier, please handle carefully so that the vehicle is not damaged further. Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
- Page 18 Please tow carefully taking precautions not to increase the damage to the vehicle. ・ If an abnormal noise, smell and/or strong vibration are observed from the vehicle while towing, stop towing immediately. Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
- Page 19 It is recommended that a warning sign (example provided above) is fixed to or on the vehicle during any emergency work on the vehicle. A sign that complies with any local legislation or meets relevant Australian Standards should be used. Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
- Page 20 Copyright © Mitsubishi Motors Australia Limited Part number AU900183, October 2010...
Need help?
Do you have a question about the i-MiEV and is the answer not in the manual?
Questions and answers