13A-118
THROTTLE BODY
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
D
Engine Coolant Draining and Supplying (Refer to
GROUP 14 – On-vehicle Service.)
D
Engine Cover Removal and Installation
D
Air Intake Hose Removal and Installation
2
4
10 – 13
Nm
3
Removal steps
1. Throttle valve control servo connec-
tor
2. Throttle position sensor connector
GDI –
Throttle Body
1
INSTALLATION SERVICE POINT
AA THROTTLE BODY INSTALLATION
If the throttle body is replaced, initialize the electronic-controlled
throttle valve system.
Initialization
Turn on the ignition switch, and turn off it within one second.
Then leave it for at least ten seconds with the ignition switch
off.
5
3. Water hose connection
AA 4. Throttle body
5. Throttle body gasket