On-Vehicle Service; Accelerator Pedal Position Switch And Accelerator Pedal Position Sensor Adjustment; Accelerator Pedal Position Sensor Inspection; Sort - Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement

Accelerator pedal
position sensor
Power steering
reservoir tank
Thickness
Fully-closed stopper
gauge
Accelerator pedal position sensor
Terminal (4)
MB991658 Terminal (5)
Accelerator pedal
position sensor
Power steering
reservoir tank
GDI <4G6> -

ON-VEHICLE SERVICE

1. ACCELERATOR PEDAL POSITION SWITCH AND
ACCELERATOR PEDAL POSITION SENSOR
ADJUSTMENT
Caution
(1) The accelerator pedal position sensor is adjusted
correctly at the time of shipment from the factory,
and so it should not normally be moved.
(2) If adjustment does become necessary, use the
following procedure.
Accelerator
<When using the MUT-II>
lever
(1) Connect the MUT-II to the diagnosis connector.
(2) Remove the two accelerator pedal position sensor
assembly mounting bolts, and then insert a thickness
gauge with a thickness of 0.60 mm in between the
accelerator lever and the fully-closed stopper.
(3) Turn the ignition switch to ON (without starting the engine).
(4) Loosen the accelerator pedal position sensor mounting
bolt, and then turn the accelerator pedal position sensor
anti-clockwise as far as it will go.
(5) Check that the idle switch turns on at this time.
(6) Turn the accelerator pedal position sensor clockwise until
the point is found where the idle switch turns off. Securely
tighten the accelerator pedal position sensor mounting
bolt at this point.
(7) Check that the accelerator pedal position sensor (1st
channel) output at this time is within the standard value
range.
Standard value: 0.5 - 0.9 V
(8) Turn the ignition switch to the LOCK (OFF) position.
(9) Remove the thickness gauge and then install the
accelerator pedal position sensor assembly.
(10)Remove the MUT-II.
2. ACCELERATOR PEDAL POSITION SENSOR
INSPECTION
(1) Disconnect the accelerator pedal position sensor
connector.
On-Vehicle Service
13A-11