Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 133

13D-68
Engine-ECU <M/T> Harness Side
Connector Terminal Arrangement
Terminal Terminal
No.<M/T> No. <A/T>
1 - 12 1 - 40
14 - 12 9 - 40
2 - 12 24 - 40
15 - 12 2 - 40
4 - 12 14 - 40
17 - 12 28 - 40
5 - 12 15 - 40
18 - 12 29 - 40
6 - 12 6 - 40
9 - 12 34 - 40
13 - Body 42 - Body
earth earth
26 - Body 48 - Body
earth earth
60 - 12 3 - 40
MPI -
4. If the ohmmeter shows any deviation from the standard
5. After repair or replacement, recheck with the ohmmeter
Inspection item
No. 1 injector
No. 2 injector
No. 3 injector
No. 4 injector
Stepper motor coil (A1)
Stepper motor coil (A2)
Stepper motor coil (B1)
Stepper motor coil (B2)
EGR control solenoid valve
Purge control solenoid valve
Engine-ECU earth
Engine-ECU earth
Oxygen sensor heater
Troubleshooting
Caution
If the terminals that should be checked are mistaken,
or if connector terminals are not correctly shorted
to earth, damage may be caused to the vehicle wiring,
sensors, engine-ECU <M/T> or engine-A/T-ECU <A/T>
and/or ohmmeter.
Be careful to prevent this!
value, check the corresponding sensor, actuator and
related electrical wiring, and then repair or replace.
to confirm that the repair or replacement has corrected
the problem.
Engine-A/T-ECU <A/T> Harness Side
Connector Terminal Arrangement
Normal condition (Check condition)
13 - 16 W (At 20_C)
28 - 33 W (At 20_C)
36 - 44 W (At 20_C)
36 - 44 W (At 20_C)
Continuity (0W)
11 - 18 W (At 20_C)