Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 988

SRS –
AIR BAG MODULE AND SEAT BELT PRE-TENSIONER DISPOSAL
PROCEDURES
Before disposing of a vehicle which is equipped
with air bags or seat belts with pre-tensioner, or
when disposing of the air bags or seat belt
Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
UNDEPLOYED AIR BAG MODULE AND SEAT
BELT PRE-TENSIONER DISPOSAL
Caution
1. If the vehicle is to be scrapped or otherwise disposed
2. Since a large amount of smoke is produced when
3. Since there is a loud noise when the air bags are
4. Suitable ear protection should be worn by personnel
AIR BAG MODULE DEPLOYMENT
Deployment Inside The Vehicle
(when disposing of a vehicle)
1. Move the vehicle to an isolated spot.
2. Disconnect the negative (–) and positive (+) battery cables
pre-tensioner themselves, the following procedures
must be used to deploy the air bags or operate
the seat belt pre-tensioners before disposal.
of, deploy the air bags inside the vehicle, and operate
the seat belt pre-tensioners outside the vehicle. If the
vehicle will continue to be operated and only the air
bag modules and seat belt pre-tensioner are to be
disposed of, deploy the air bags and operate the seat
belt pre-tensioners outside the vehicle.
the air bag are deployed or the seat belt pre-tensioner
is operated, avoid residential areas whenever possible.
deployed and when the seat belt pre-tensioners are
operated, avoid residential areas whenever possible.
If anyone is nearby, give warning of the impending
noise.
performing these procedures or by people in the
immediate area.
from the battery terminals, and then remove the battery
from the vehicle.
Caution
Wait at least 60 seconds after disconnecting the battery
cables before doing any further work.
(Refer to P.52B-3.)
52B-39
52400120317