Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 854

Window spacer
attachment positions
BODY –
Window Glass
8. Finish the flange surfaces so that they are smooth.
Caution
(1) Be careful not to remove more adhesive than is
necessary.
(2) Be careful also not to damage the paintwork on
the body surface with the knife. If the paintwork
is damaged, repair the damaged area with repair
paint or anti-rust agent.
9. When reusing the windshield, remove the adhesive still
adhering to the windshield, and clean with isopropyl
alcohol.
10. Clean the body side in the same way.
Caution
Let the cleaned places stand for 3 minutes or more,
and carry out the next procedures after they have
dried. Also, do not touch any surface that has been
cleaned.
INSTALLATION SERVICE POINTS
AA WINDOW SPACER INSTALLATION
After wiping the window spacer adhesion surfaces of the
windshield with isopropyl alcohol to remove any grease, attach
the window spacers in the positions shown in the illustration.
BA WINDSHIELD INSTALLATION
1. When replacing the glass, temporarily set the glass against
the body, and place a mating mark on the glass and body.
2. Use isopropyl alcohol to degrease the inside and outside
of the windshield glass and the body flanges.
3. Soak a sponge in the primer, and apply evenly to the
glass and the body in the specified places.
4. Apply the primer, and then let it dry for 3 to 30 minutes.
Caution
(1) The primer strengthens the adhesive, so be sure
to apply it evenly around the entire circumference.
However, a too thick application will weaken the
adhesive.
(2) Do not touch the coated surface.
42-11