Mitsubishi MOTORS Space Runner 1999 Workshop Manual Supplement page 183

16-8
Insulated
brush holder
Free
Lock
New brush
Pigtail
ENGINE ELECTRICAL -
BRUSH HOLDER CHECK
Check the continuity between brush holder plate and brush
holder.
If there is no continuity, the brush holder is in order.
OVERRUNNING CLUTCH CHECK
1. While holding clutch housing, rotate the pinion. Drive
2. Inspect pinion for wear or burrs. If pinion is worn or burred,
FRONT AND REAR BRACKET BUSHING CHECK
Inspect bushing for wear or burrs. If bushing is worn or burred,
replace front bracket assembly or rear bracket assembly.
BRUSH AND SPRING REPLACEMENT
1. Brushes that are worn beyond wear limit line, or are
2. When replacing field coil brushes, crush worn brush with
Wear limit line
3. Sand pigtail end with sandpaper to ensure good soldering.
4. Insert pigtail into hole provided in new brush and solder
Soldered (Make
sure that there is
no excess solder
5. When replacing ground brush, slide the brush from brush
on blush surface)
Surface marked
Starting System
pinion should rotate smoothly in one direction, but should
not rotate in opposite direction. If clutch does not function
properly, replace overrunning clutch assembly.
replace overrunning clutch assembly. If pinion is damaged,
also inspect ring gear for wear or burrs.
oil-soaked, should be replaced.
pliers, taking care not to damage pigtail.
it.
Make sure that pigtail and excess solder do not come
out onto brush surface.
holder by prying retainer spring back.