<Air bag module (front passenger's side>
Air bag module removal steps
EA D Post-installation inspection
D Negative (–) battery cable connection
Section A-A
A
Mounting screw
(Torx screw)
Lock
SRS –
Air Bag Modules and Clock Spring
1
A
A
REMOVAL SERVICE POINTS
AA
1. Remove the air bag module mounting screws (torx screws)
at the sides of the steering wheel.
NOTE
Do not remove the screws from the holders.
A
2. When disconnecting the connector of the clock spring from
the air bag module, press the air bag's lock towards the
outer side to spread it open. Use a flat-tipped screwdriver,
as shown in the figure at the left, to pry so as to remove the
connector gently.
Caution
(1) When disconnect the air bag module clock spring
Lock
(2) The removed air bag module should be stored
Connector
Flat-tipped
screwdriver
Section A-A
Instrument panel
AD
1. Air bag module
AA D Pre-installation inspection
AIR BAG MODULE REMOVAL (DRIVER'S SIDE)
connector, take care not to apply excessive force
to it.
in a clean, dry place with the pad cover face up.
52B-31
1
Claw