Syslog Client; Show Events Syslogserver; Commands In The Events Configuration Mode - Siemens SCALANCE W760 Configuration Manual

11.2

Syslog client

With the commands in this section, the following settings are configured:
● Transfer of the messages to the Syslog server
● Local buffering and storage of messages
● Receipt and forwarding of messages from other devices (relay mode)
11.2.1

show events syslogserver

Description
This command shows the entries of the configured Syslog server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show events syslogserver
Result
The entries of the configured Syslog server are displayed.
11.2.2

Commands in the Events configuration mode

This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the EVENTS configuration mode with the
Global configuration mode.
● If you exit the EVENTS configuration mode with the
Privileged EXEC mode.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
or
cli#
command to change to this mode.
events
command, you return to the
exit
command, you return to the
end
Diagnostics
11.2 Syslog client
423