Configuring The Traffic Channel Parameters - Agilent Technologies 8960 Series Programming Manual

Step 2: Configure the Base Station Emulator (BSE)

Configuring the Traffic Channel Parameters

The traffic channel parameters are configured using the CALL processing subsystem commands shown in the
following table.
Table 2. Traffic Channel Settable Parameters
Parameter Command Syntax
TCH Band CALL:TCHannel:BAND <PGSM|EGSM|DCS|PCS>
Channel CALL:TCHannel[:ARFCn][:SELected] <numeric value>
Number
OR
CALL:TCHannel[:ARFCn]:<PGSM|EGSM|DCS|PCS> <numeric value>
Loopback Mode CALL:TCHannel:LOOPback <OFF|A|B|C>
Timeslot CALL:TCHannel:TSLot <numeric value>
Downlink CALL:TCHannel:DOWNlink:SPEech
Speech Source <NONE|ECHO|PRBS15|SIN300|SIN1000|SIN3000>
XXXXXXXXX XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
Table Footnotes
1 The TCH band setting becomes the selected band (see Note 2).
2 Sets the TCH channel for the TCH band selected with the TCH Band command (see Note 1).
Example 2. Programming Example:
The following program example illustrates proper use of the BSE TCH configuration commands. Not all
parameters are accessed.
OUTPUT Test_set;"CALL:TCH 45"
OUTPUT Test_set;"CALL:TCH:TSL 4"
22
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Proguide\Chapters\prog_prog_guide_step2.fm
Footnote
1
2