Table of Contents
Advertisement
2
Using the Oscilloscope
Front Panel Inputs and Outputs
On the Infiniium 90000 X- Series oscilloscopes, the channel inputs and the
Aux Out and Cal Out outputs appear on the lower part of the front panel.
The ground plug, probe compensation terminal, and three USB host ports
are also located here.
Figure 7
Infiniium 90000 X-Series Oscilloscope Front Panel I/O
Channel Inputs
The four channel inputs have:
• 3.5 mm threaded RF connectors.
• A convenient automatic torque mechanism.
• An AutoProbe II interface connector with pins that provide probe
The AutoProbe II interface works with the InfiniiMax III probing system.
See
You can also connect 3.5 mm threaded RF cables to the channel inputs.
Ground
The ground plug is convenient for ESD wrist straps.
Aux Out
This output signal is selected by the Infiniium oscilloscope application's
Calibration Output dialog box. It can be a DC level, the probe
compensation signal (a square wave used to adjust compensated passive
probes), the trigger out signal, or a demo signal.
Cal Out
This calibration output is used when performing user calibration on the
oscilloscope.
A calibration cable is included with the oscilloscope.
26
power, identification, and other communication signals.
"Connecting oscilloscope probes"
on page 17.
Agilent Infiniium 90000 X-Series Oscilloscopes User's Guide
Advertisement
Table of Contents
