Removing And Replacing The Bridge Foot - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
4.2 Removing and Replacing the Bridge
Foot
Tools: None
Remove:
1. Put the bridge in the down position and in heavy mode.
2. Unscrew the two (2) thumb screws, one on each side of the foot. Refer to
Figure 4-1.
1
4
–Foot face plate. –Six (three each side) face plate screws.
–Two thumb screws. –Media purchase sensor connector.
3. Lift the bridge and pull the foot out.
Replace:
1. Reverse the procedures above.
4-2 Removal and Replacement
2
Figure 4-1 Bridge foot.
–Loop sensor connector.
2
3
5