Table of Contents
Advertisement
Maintenance
Transport unit (TU), removing paper dust
Vacuum cleaner, brush, Isopropanol (plastic-
coated rollers, rubber rollers)
− Unlock the TU, pull it out on the telescopic
rails and open it.
− Remove the paper dust with a vacuum
cleaner.
− Clean the sensors with a brush.
− Clean the transport rollers.
− Push in the TU and lock it.
Single sheet buffer (SR) and sheet bridge (SB), removing paper dust
Vacuum cleaner, brush
− Unlock the transport unit (TU) and pull it out
on the telescopic rails.
− Pull up the quick-action lock (1), pull the
cover plate of the single sheet buffer a little to
the front and remove it.
− Hold the sheet bridge (SB) on the right side
and fold it open to the left (3).
− Remove the paper dust with a vacuum
cleaner.
− Set the sheet bridge back to its initial position.
Mind the lock-in position.
− Push the cover plate of the single sheet buffer
into the holding brackets (2) at the back and
fasten it at the front by snapping in the quick-
action lock.
− Push in the TU and lock it.
8.8
2003-06-01 /PN 9008
Operation
dlab2b09
dlab2008
AGFA d-lab.3
Advertisement
Table of Contents
