AGFA Avantra 36/44 Service Manual page 71

Avantra 36/44 Service Manual
1
2
2.13.4.1 Outriggers
An outrigger attaches to each inner shroud. The outriggers prevent smaller sized
media from curling during a load.
2.13.4.2 Brushes
Three sets of brushes attach to each inner shroud. An individual solenoid controls
each brush. During imaging and certain feed sequences, the brushes position either
up or down. Brush control is determined by the values loaded in the DEC Image/
Focus/Bridge Menu for film, paper and plate material.
NOTE:
On the Avantra 36/44 the drivers for the brushes are on the
SDM board. On the 36S/44S the brushes are on the carriage
board
2-22 Functional Analysis
Figure 2-10 Inner shroud.
–Solenoids. –Brushes. –Outrigger.
3