Circulation Pumps - AGFA Avantra 36/44 Service Manual

7.0 Water Solenoid Valve
7.1 Water solenoid valve is activated constantly.
7.2 Water solenoid valve is never activated.
7.3 Incorrect water flow.

8.0 Circulation Pumps

8.1 Circulation pumps are constantly active.
8.2 Pumps are never active.
9.0 Film Input
9.1 Film input constantly active and film input LED lights constantly.
9.2 Film input sensor activated, LEDs on, but main motor/rollers are okay.
10.0 Low Level
10.1 Low level LED is on even though level is not low.
10.2 Low level LED does not light even though level is low.
10.3 Main motor, dryer fan, etc. start even though low level appears.
11.0 Replenish Empty
11.1 Replenishment empty LED is flashing even though replenisher contain-
ers are not empty.
11.2 Replenishment empty LED does not light even though replenisher con-
tainers are empty.
12.0 Jog Mode
12.1 Jog mode does not activate main motor and circulator pumps within 5
minutes.
13.0 Display Readout
13.1 0° C. or 70° C. (or more) indicated as DEV.–FIX. or DRY. TEMP.
13.2 Message MOTOR OVERLOAD or MOTOR OFF–DiSCONNECT MAINS.
13.3 Message 2001H.
13.4 Messages 2002H, 2003H, or 2004H.
13.5 Messages: JOB IN PROCES, INPUT JAM, EXIT JAM, MANUAL START.
Table 4-2 Problem codes (continued from previous page).
Section IV: On-line Processor
Maintenance 4-19