10. Slide the extension platen toward the rear of the imagesetter.
CAUTION:
Before proceeding to the next step make certain that no
interference exists between the bridge (when it is lowered) and the
edge of the extension platen.
11. Lower the bridge.
12. Slide the extension platen toward the bridge. Using the two (2) platen
alignment pins provided, align the holes on the bottom of the bridge
platen (left and right) with the holes in the extension platen. Refer to
Figure 1-12.
1
Figure 1-12 Aligning the bridge platen and extension platen.
–Imagesetter. –Alignment hole on the extension platen.
3
2
–One of two alignment pins provided.
Section III: Buffer
Installation 1-13