Heating Element - AGFA Avantra 36/44 Service Manual

3.9

Heating Element

The following describes how to remove and replace the heating element.
Tools Required: Adjustable open end wrench
Remove:
1. Turn off and unplug the OLP.
2. Remove the top and side covers.
3. Drain the tank.
4. Follow the red, white, green/yellow power wires (electrical connection) to
the terminal block and disconnect. Refer to Figure 3-14.
Note the wire positioning for proper replacement.
5. Loosen the PVC nut on the outside of the tank. Refer to Figure 3-14.
6. Slide the heating element out. Refer to Figure 3-14.
2
3
WARNING: DO NOT OVER-TIGHTEN
Figure 3-14 The heating element assembly.
–Heating element assembly. –Heating element O-ring.
–PVC compression nut. –Power wires (electrical connector).
Section IV: On-line Processor
1
Removal and Replacement 3-17
4