AGFA Avantra 36/44 Service Manual page 290

Avantra 36/44 Service Manual
5. With the rear of the bridge tilted downward and the bridge aligned over
the mounting bracket holes in the imagesetter, slowly lower the bridge into
place. Refer to Figure 1-8.
6. Hand tighten the three (3) allen cap screws, in the bearing blocks, left and
right (see Figure 1-11).
7. Unclip the cable from the capture bar eyelet. Push the boom and cable out
of the way.
8. Remove the 9/16" bolt and washer from the capture bar bracket, left and
right (see Figure 1-6).
Figure 1-8 Lowering the bridge into the imagesetter.
–Crane. –Capture bar brackets. –Bridge. –Imagesetter.
1-8 Installation
1
2
3
4