AGFA Avantra 36/44 Service Manual page 431

Avantra 36/44 Service Manual
5. Remove the allen set screw from the belt wheel. Refer to Figure 3-22.
6. Remove the three (3) J-hooks (two at the center, one at the rear). Refer to
Figure 3-23 and Figure 3-24.
7. Using a 10mm wrench, remove the bolts from the three (3) bearing brack-
ets (located at the front, center and rear). Lift the drive shaft back and out.
Refer to Figure 3-22, Figure 3-23, and Figure 3-24.
1
–Bearing bracket (center). –Two J-hooks (center).
3-28 Removal and Replacement
2
Figure 3-23 Bearing bracket and J-hooks.