4. The light shield on the left requires a twist toward the door to remove. Pull
the light shield on the right straight out.
NOTE: When removing the light shield, the interlock switch, located
above the shield, automatically shuts off the laser and spin
motor.
Replace:
1. Reverse the above removal procedure.
4.6.2 Spin Motor Module (SMM)
Tools Required: 5/32" allen wrench
Remove:
1. Open the left side cover. See Section 4.2.1, Right/Left Side Covers.
2. Remove the left inner light shield by pulling the five latching knobs. See
Section 4.6.1, Light Shields (Right and Left).
3. Remove the spin motor signal and encoder cables from the carriage board.
Refer to Figure 4-32.
Section I: Imagesetter
Removal and Replacement 4-47