Luth Rectifier Board (Lrb) - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
Replace:
1. Do not clean the silicon off the back of the chassis.
2. Reverse the order of the removal steps above, being careful to reattach the
connectors into their proper plugs.
3. When the board is in place, make sure that the LED is in proper alignment
with the CPU LED. Refer to Figure 3-7.
4. Check the jumper settings. Refer to Chapter 4, OLP Maintenance.
5. Perform the motor speed calibration. Refer to Chapter 4, OLP Maintenance.
3.5 LUTH Rectifier Board (LRB)
Tools Required: Needle-nose pliars, small flathead screwdriver
Remove:
1. See the removal procedures in Section 3.3, CPU-OLP for exposing the
board.
2. Using a small flathead screwdriver, remove the wires from the two (2) ter-
minal blocks on the bottom of the board. Refer to Figure 3-8. Note the wire
positions for replacement.
3. Using a needle-nose pliars, release the four (4) nylon standoffs. Refer to
Figure 3-8.
3-10 Removal and Replacement