AGFA Avantra 36/44 Service Manual page 137

Avantra 36/44 Service Manual
To Restore:
1. Connect the PC to the diagnostic serial port of the system.
2. Turn the system on and allow the boot cycle to complete.
3. Launch the AVDIAG Program from the PC.
4. Under the ALIGN menu, select DEC Machine Parameters and press ENTER.
If AVDIAG was relaunched, the following dialog appears:
Loading Dec. EEPROM Machine Parameters into memory.
5. Select N in the dialog box and press ENTER.
6. Select Restore to Engine and press ENTER.
7. A dialog box appears with all the saved DEC files. Select the file with the
same serial number and extension saved in Step 7 in the save procedures
above and press ENTER.
The Machine parameters will now load to the imagesetter. When com-
pleted, the following dialog boxes appear:
Dec. EEPROM Machine Parameters have been restored to the engine.
8. Values will not take effect until the imagesetter is reset. Select Y and wait
for the imagesetter to reset.
3-50 Diagnostics