AGFA Avantra 36/44 Service Manual page 457

4.5.1.5 OLP Status and Error Messages
The following status and error messages are displayed at the OLP control panel.
Job in Process
Meaning: Media is currently in the processor and no new job has started imaging
since the last piece of media entered the processor.
Action: No action required. Status message only.
Input Jam
Meaning: Media activated the input sensors of the processor, but did not reach the
input out sensors in the given amount of time.
Action: Check the processor input rollers for a possible media jam.
Exit Jam
Meaning: Material has entered the processor, but did not reach the processor exit
sensor in the given amount of time.
Action: Check processor for possible media jam. Check that the media keeps the
exit sensor active when entering the receiving basket. Lower the sensor
mounting bracket or raise the lower platen as needed.
Motor Overload (Or Disconnect Mains + Motor OFF)
Meaning: The processor has detected an error in the transport drive system.
Action: Inspect the processor for possible media jam, damaged gears, or binding
drive system. Check that the door and dryer interlocks are fully engaged.
Disconnect and reconnect the mains (power) to the OLP to clear the
error. If the error persists, refer to the troubleshooting tables: Table 12-5,
12-6 and 12-7. If 24V DC drive motor is present, check the jumper setting
for current limiter.
Manual Start
Meaning: The manual start key on the control panel has been activated.
Action: As soon as the manual start key is pressed again, the message disap-
pears.
Section IV: On-line Processor
Maintenance 4-25